World War I Homecoming Medal for Returning Soldiers
Description
World War I Medal or award. Bronze stylized inner seal of Lancaster. Given to soldiers returning from WWI in 1919. (Safety pin sewn to ribbon on back.) See Journal article, vol. 97, #2.
medallion for marksmanship(?). Gold circle with two gold rifles intersecting in X behind blue and yellow target in medal's center. Reads: "Penna. State Champion / 1924 / Class B" awarded to John E. Schroll
Liberty Bell pendant medallion with Independence Hall on the back. Outline of bell has contoured image of Liberty Bell with inscription, crack and clapper. Inscription at top reads "OF LEV XXV&X PROCLAIM / IN PHILDA. BY ORDER OF TH--" and below this is "PASS AND STOW / PHILADA. / MDCCLIII."
Back is flat with a raised image of Independence Hall. Extended tab at top has hole with two linked wire rings for hanging.
Tatting hook of bone handle shaft of iron hook set into smaller end.
Tool has handle of elongated teardrop shape, somewhat flattened in cross-section. Wire-like shaft with rounded hook on tip is set into handle. Shaft is thicker than hooked end.
Provenance
Collected by Lillian Hollings Kiker, born to Scottish Americans who lived in New Jersey. Born (1912) and lived in New Jersey, last of Egg Harbor, she was active with quilting, sewing, knitting & crocheting. Collection inherited by donor when her mother passed away.
Set of tatting tools, nickel silver plated steel, has four pieces. Each piece has in common the shaped and decorated portions, the handles of the three tools and the needle case body. This feature is a flattened octagonal shape in cross-section, with successive divots ground out with a round grinding wheel. Handles and case all taper along their length.
A. Needle case is 2.75" long and .375" wide. At the heavier end of case is a fitted cap that slides onto a smaller male extension protruding from main body. Seam visible along sides where both halves of case have been joined.
B. Hook on handle is 4" long and .25" wide. Tapers from handle end down to where shaft is attached. Shaft has ball-and-ring at handle, a slight swell along length and a minute hook at tip.
C. Awl is 3.625" long and .25" wide. Same handle as above. Shaft is similar in shape except heavier and shorter and has a sharp tip.
D. Threading tool(?) is 3" long and .5" long. Same handle as above. Shaft is shorter and has a large open loop in a teardrop shape.
Provenance
Collected by Lillian Hollings Kiker, born to Scottish Americans who lived in New Jersey. Born (1912) and lived in New Jersey, last of Egg Harbor, she was active with quilting, sewing, knitting & crocheting. Collection inherited by donor when her mother passed away.
