P95.02.01A: Crystal ball is a sphere of clear glass containing tiny interior bubbles and barely perceptible striations on the surface corresponding to lines of latitude.
P95.02.01B: Base for ball is a turned disk of pine with recessed top in which to
Place of origin is unknown.
Provenance
9/07/2012 - Transferred from HC Collections; 12/29/94 - Purchase from Book Haven 146 N. Prince Street, Lancaster, PA 17603
Glass ball has minor surface abrasions or imperfections; some small nicks and scratches in the base, and a 1/2" area of finish loss on the center of the bottom.
Pewter basin, part of the Warwick Congregation's (now known as the Brickerville United Lutheran Church) communion service.
High, rounded sides flare out to a flattened rim with rolled edge. Booge appears to be unhammered. Barns struck his large circular mark with an eagle on the inside of bottom. The left portion of the eagle as well as the letters "BAR" on the bottom are discernible, as well as the "HE" above the eagle.
Probably made in Middletown or Wallingford, Connecticut.
Provenance
The entire communion service remained in use over the years until the congregation decided in 1997 to find a safe place for this valuable communion set. Purchased by the Heritage Center of Lancaster County.
Pewter beaker or handleless cup. Part of the Warwick Congregation's (now known as the Brickerville United Lutheran Church) communion service.
Cylinder form flares out slightly at bottom as well as top. Banded at base.
Engraved on the exterior, near top, are the small initials "M.W."
Provenance
The entire communion service remained in use over the years until the congregation decided in 1997 to find a safe place for this valuable communion set. Purchased by the Heritage Center of Lancaster County.
Diameter of bottom is listed. Diameter of top is 2.5".
Condition
Good
Condition Date
2014-08-28
Condition Notes
Overall abrasions, pitting, small dents and staining. Rim has multiple small dents and abrasions. Bottom interior is pitted. Wear underneath with some areas slightly cracked. Dent at base.
Object ID
P.97.08.5
Place of Origin
Hartford, Connecticut
Credit
Acquired through the generosity of the James Hale Steinman Foundation and Friends of the Heritage Center Museum, Heritage Center Collection
Stiletto or bodkin of turned bone, fitted in a conical basket-weave holder or sheath.
Stiletto (A) has ball-shaped head with hole in it, then narrowing to a neck with additional swells and narrowing until it tapers from midsection down to a sharp point.
Holder (B) is an elongated cone made with a brown reed-like material woven onto ribs like a basket. Handle is a twisted form of the same material, shaped in a double loop configuration.
It is assumed that this pair of otems were originally dwsigned for each other.
Provenance
Collected by Lillian Hollings Kiker, born to Scottish Americans who lived in New Jersey. Born (1912) and lived in New Jersey, last of Egg Harbor, she was active with quilting, sewing, knitting & crocheting. Collection inherited by donor when her mother passed away.
Bodkin of bone is a flattened needle with one rounded end and one end with a blunt point. Slot of 5/8" in length is cut into body near rounded end. This tool is used for threading ribbons, etc. through casings, fabric tubes or loops.
Provenance
Collected by Lillian Hollings Kiker, born to Scottish Americans who lived in New Jersey. Born (1912) and lived in New Jersey, last of Egg Harbor, she was active with quilting, sewing, knitting & crocheting. Collection inherited by donor when her mother passed away.
Bodkin of steel is a blunt needle used for threading ribbons or other fabric through casings, loops, etc.
Two thin pieces of tapered steel are laminated together through half their length at narrow end. Two pieces at wider end are separated, allowing a ribbon or other material to be fitted into "jaws" and clamped in place via a sliding mechanism fitted into slot that extends lenthwise toward jaws. Inside of jaw ends have 3 pairs of raised barbs or teeth that enable the jaws to hold material without slipping.
Stamped on one side at midsection is "THE DOT." This likely refers to the rounded sliding mechanism fitted in the slot.
Provenance
Collected by Lillian Hollings Kiker, born to Scottish Americans who lived in New Jersey. Born (1912) and lived in New Jersey, last of Egg Harbor, she was active with quilting, sewing, knitting & crocheting. Collection inherited by donor when her mother passed away.
Bodkin of steel is a blunt needle used for threading ribbons, tape or other fabric through casings, loops, etc.
Bodkin is two thin pieces of tapered steel that are laminated together through half their length at narrow end. Two pieces at wider end are separated, allowing a ribbon or other material to be fitted into "jaws" and clamped in place via a sliding mechanism fitted into slot that extends lenthwise toward jaws. Jaws are enabled to hold material without slipping via two raised beads stamped into one side and two matching holes on other side.
Stamped onto one side of tool at midsection is "PATD. MAR. 29. 92."
Provenance
Collected by Lillian Hollings Kiker, born to Scottish Americans who lived in New Jersey. Born (1912) and lived in New Jersey, last of Egg Harbor, she was active with quilting, sewing, knitting & crocheting. Collection inherited by donor when her mother passed away.
Ribbon threader or bodkin is a blade of nickel-plated non-ferrous metal, in a torpedo shape, wide and rounded at one end and tapering to a point at other end. Two slots are cut in wide end for stringing ribbon that needs to be threaded through casings in waistbands, wristbands, etc.
Stamped inscriptions: On one side of tool is "RIBBON THEADER", "REGISTERED", "No. 3", AND "K.B.C.".
Provenance
Collected by Lillian Hollings Kiker, born to Scottish Americans who lived in New Jersey. Born (1912) and lived in New Jersey, last of Egg Harbor, she was active with quilting, sewing, knitting & crocheting. Collection inherited by donor when her mother passed away.
Chinese export bowl of high fired porcelain, polychrome decoration under glaze. Thin walled in nearly hemispherical form sitting on a 3/4" raised foot. Gold-painted rim with red edging. Two goldfish inside bottom. Continuous landscape on exterior is the same repeating Roman or Greek scene of a seated half-robed seated man with dog facing three nude women and seated baby. All set against distant mountains and one tree in foreground.
Large redware mixing bowl, with dark red-brown glaze inside. Spout formed at lip. Two applied handles at sides. Glaze splashed and dripped onto other areas of bowl, including sides, handles, and underside of lip.
Large areas of glaze loss, as well as multiple small losses. Scratches and pinpricks in surface. The edge is worn. Some chunks of bottom edge are missing.
Object ID
G.80.123.6
Place of Origin
Southeastern Pennsylvania
Credit
Heritage Center Collection, gift of Mrs. Paul A. Mueller