Six-piece sewing kit, composed of a clam-shell-type, blue leather case with stamped gold trim. Case has eight sides and lid is hinged with spring activated clasp. Interior has ivory-colored velvet in bottom section and satin on lid. Bottom section has recessed cavities that conform to the shape of each of the following sewing equipment:
1. Scissors, polished steel blades, gold-plated non-ferrous metal handles, marked "NOGENT" and "34" on blades. Gold finish is worn. Length: 4" Perhaps made by Nogent in France
2. Thimble, gold finish, bottom 1/3 of sides has diamond shapes on a ground of wavy lines. Unmarked.
3. Awl or stiletto, round steel shaft set onto handle of gold-plated non-ferrous metal. Gold finish worn. Length: 3.75"
4. Crochet-type hook, round steel shaft w/ minute hook at end, set onto handle as above. Gold finish worn. Length: 3.875"
5. Flat needle/bodkin for threading ribbon, etc.; slot and adjacent hole at one end and near point at other. Gold finish worn on non-ferrous metal. Fits into elastic loop in case. Length: 2.25"
6. Needle case of gold-plated non-ferrous metal, conventional shape. Main body has 0.5"-long fitted cap. The flattened sides are stamped with a pattern of wavy lines. Length: 2" Width: 0.25" Thickness: 0.125"
Inscriptions: No marking noted on anything except for scissors, "NOGENT." Internet search reveals Nogent as a cutlery factory near the village of Nogent in NW France. Although this factory seems to have begun in 1923, the area around Nogent has been a "cradle of cutlery making" for three centuries.
Provenance
Collected by Lillian Hollings Kiker, born to Scottish Americans who lived in New Jersey. Born (1912) and lived in New Jersey, last of Egg Harbor, she was active with quilting, sewing, knitting & crocheting. Collection inherited by donor when her mother passed away.
Set of tatting tools, nickel silver plated steel, has four pieces. Each piece has in common the shaped and decorated portions, the handles of the three tools and the needle case body. This feature is a flattened octagonal shape in cross-section, with successive divots ground out with a round grinding wheel. Handles and case all taper along their length.
A. Needle case is 2.75" long and .375" wide. At the heavier end of case is a fitted cap that slides onto a smaller male extension protruding from main body. Seam visible along sides where both halves of case have been joined.
B. Hook on handle is 4" long and .25" wide. Tapers from handle end down to where shaft is attached. Shaft has ball-and-ring at handle, a slight swell along length and a minute hook at tip.
C. Awl is 3.625" long and .25" wide. Same handle as above. Shaft is similar in shape except heavier and shorter and has a sharp tip.
D. Threading tool(?) is 3" long and .5" long. Same handle as above. Shaft is shorter and has a large open loop in a teardrop shape.
Provenance
Collected by Lillian Hollings Kiker, born to Scottish Americans who lived in New Jersey. Born (1912) and lived in New Jersey, last of Egg Harbor, she was active with quilting, sewing, knitting & crocheting. Collection inherited by donor when her mother passed away.